20) The installer shall supply all information concerning manual operation of the system in case of an emergency, and shall hand over to the user
the warnings handbook supplied with the product.
21) Do not allow children or adults to stay near the product while it is operating.
22) Keep remote controls or other pulse generators away from children, to prevent the automated system from being activated involuntarily.
23) Transit through the leaves is allowed only when the gate is fully open.
24) The user must not attempt any kind of repair or direct action whatever and contact qualified personnel only.
25) Maintenance: check at least every 6 months the efficiency of the system, particularly the efficiency of the safety devices (including, where
foreseen, the operator thrust force) and of the release devices.
26) Anything not expressly specified in these instructions is not permitted.
FUNCTIONS
These instructions apply to the following models: Operators SWING
The SWING AUTOMATION SYSTEM for swing gates comprises two electromechanical operators which drive the gate leaves by means of a
worm screw. The system locks mechanically; therefore no electric lock is required.
To obtain anti-crushing protection, you have to use electronic control units with a torque control electronic device.
The SWING automation was designed and manufactured to control access of vehicles.
Avoid any other use whatever.
To Next Page
Loading...
General