IMPORTANT! DANGER OF CRUSHING.
If the power cable of operator SWING is damaged, it must be replaced by qualified personnel, using a new cable of the same type. Do
not use different power cables.
TOOLS AND MATERIALS
Tools you will require to install the SWING operator:
1. Set of flat wrenches for hexagon head screws
2. Set of screwdrivers for cross-head and cut-head screws
3. Set of wall bits
4. Set of iron bits
5. Flat-nose pliers
6. Saw on metal
7. A hammer drill
8. Folding rule (2 m)
To Next Page
Loading...