1601-065-P-12-19
17
9410
9409
Dual Channel
Single Channel
3.5 Operator Timer ON Entry Lane (No Down Loop)
REVERSE
SENSITIVITY
TIME
DELAY
POWER
1
ON
2 3 4 5 6 7 8 1
ON
2 3 4 5 6 7 8
NC NO
UP
LOOP
DOWN
LOOP
123456 789 10 11 12 13 14
1601
Speed Bump
Reverse Loop
Reverse Loop
Access
Control
Device
Reverse loops wired in series.
Com
NO
Com
NO
SW 1
SW 2
A
B
Photo Sensor Note: This should be installed to protect pedestrians from the
lowering arm. Photocell MUST be mounted directly under arm.
This does NOT protect against tailgating vehicles. Arm will always raise
when photo beam gets obstructed.
Arming Loop Note: The arming loop only allows the access control device to
function when a vehicle is on the loop, otherwise it will not function. This
prevents pedestrians from gaining access through the vehicular gate.
Reverse Loop Note: The reverse loops will prevent the arm from closing on
a vehicle remaining in the arm’s pathway. The timer will restart the
countdown any time the reverse loop gets activated.
Arming Loop
for Access
Control Device
(Optional)
SW 1
SW 1, switch 4 is OFF.
SW 1, switch 7 is ON (Timer). The arm will
lower after the timer has timed out.
Adjust from 1 second
(full counter clockwise)
to approximately 59
seconds (full clockwise).
1 59
TIME
DELAY
A
B
Helps increase distance
and time between vehicles.
1
ON
2 3 4 5 6 7 8
Main Terminal
NOT A WALKWAY
NOT A WALKWAY
Note: Make sure that a vehicle
can NOT fit in the area
between the reverse loops.
Photo Sensor
Jumper
Loop 1
Com
Reverse
Type of wiring to be used on ALL external devices:
A) Type CL2, CL2P, CL2R, or CL2X.
B) Other cable with equivalent or better electrical,
mechanical, and flammability ratings.
To Next Page
Loading...
