1601-065-P-12-19
35
8.4 Accessories Parts List
The following accessories are available for 1601 and 1602 barrier gate operators.
Plug-In Loop Detector - Plug directly into ports on circuit board simplifying wiring.
P/N 9410-010 - Single channel detector.
P/N 9409-010 - Two channel detector.
P/N 9411-010 - Single channel detector with aux relay. Controls arm lowering for vehicles but NOT for pedestrians.
P/N 9416-010 - Single channel low power draw detector
P/N 9415-010 - Dual channel low power draw detector
Loop Wire - XLPE insulation is available in 500 and 1000 foot rolls, available in Black, Blue and Red insulation.
Loop Sealant - P/N 2600-771 Asphalt P/N 2600-772 Concrete
Manual Release Kit for the 1601 or 1602 - Installs on operators WITHOUT the convenience open. P/N 1601-270
Meg Ohm Meter - Checks the integrity of ground loops. P/N 9401-045
Interconnection Cable - Interconnection cable contains all the necessary wires to interconnect primary / secondary operators.
Cable length: 30 ft. - P/N 2600-755 40 ft. - P/N 2600-756 50 ft. - P/N 2600-757
High Voltage Kit - Alter the input AC voltage on a 115 VAC 1601/1602 to 208, 230, 460 or 575 VAC. P/N 2600-266
Reverse Edge - Installs on the bottom of round aluminum or wood arm.
P/N 8080-071 - 2-wire 6 ft.
P/N 8080-091 - 4-wire 6 ft.
Photo Cell - Prevents arm from lowering on vehicles or pedestrians.
Miller Edge Reflective-Guard Model RG
Miller Edge Prime-Guard Model PG
EMX Industries Model IRB-MON
EMX Industries Model IRB-RET
Omron Model E3K-R10K4
Seco-Larm Model E-936-S45RRGQ
Seco-Larm Model E-960-D90GQ
Manual Gate Control Toggle - Allows user to manually operate gate arm. Fits inside single-gang electrical box. P/N 1200-017
Time Clock - 7 day clock, used to automatically open gate at pre-set time, fits inside operator. P/N 2600-791 7 day clock
Surge Devices - Helps prevent circuit board failure caused by lightning strikes and power surges.
P/N 1879-080 - High Voltage P/N 1878-010 - Low Voltage
Replacement Battery - Convenience open system. P/N 1801-009 (2 required)
Speed Bump - Prefabricated 6-foot speed bump reduces traffic speed through gate system. P/N 1610-150
Heater Kit - Thermostatically controlled heater for cold weather areas. 115 VAC - P/N 1601-092
Fan Kit - Thermostatically controlled fan for hot humid environments. P/N 1601-093
LED Traffic Light (Red, Green) - Manage the traffic flow with LED red-green lights. Bolts onto the 1601 or 1602 operator.
P/N 1603-221 - 6 Ft Cable with NO Post
P/N 1603-222 - 6 Ft Cable with 35” Post
P/N 1603-223 - 11 Ft Cable with 95” Post
Gate Tracker™ - Optional control board allows the barrier gate operator to report activity to a companion 1830 series access control system.
DKS Lane Barrier - Easy add-on to the 1601 operator ONLY. Ideal in applications where a higher degree of vehicle traffic control is desired.
P/N 1620-080 - 9 Ft Lane
P/N 1620-081 - 10 Ft Lane
P/N 1620-083 - 12 Ft Lane
P/N 1620-085 - 14 Ft Lane
1601 arm kit part numbers are located on pages 2 and 3.
1602 arm kit part numbers are located on page 4.
To Next Page
Loading...
