6006-065-B-3-20
8
Sample Installation
115 VAC Standard Control Bo
x
Dual Gate Operators “Opening to the Inside”
Hinge Placement Note: It’s important to consider hinge
placement on a pilaster or a thick wall when installing the
gate. Placing hinges close to the corner can eliminate a
potential entrapment area (See Swing Gate Requirements
on page 2).
INSTALLATION
Note: Handle can be rotated and locked on
either side of operator for easy key access.
Prior to beginning the installation of the swing gate operator, we suggest that you
become familiar with the instructions and illustrations in this manual. This will
help insure that your installation is performed in an efficient and professional
manner compliant with UL 325 safety and ASTM F2200 construction standards.
The proper installation of the vehicular slide gate
operator is an extremely important and integral part
of the overall access control system.
Check all local
building ordinances and building codes prior to
installing this operator. Be sure your installation
is in compliance with local codes.
Carriage
Handle
90°
Unlock handle with key.
Rotate handle 90° to
release carriage.
Manual Release
Handle
To Next Page
Loading...
