9150-065-V-12-12
1
WARNING
MOVING GATE CAN CAUSE
Operate gate only when gate area is in sight
and free of people and obstructions.
Do not allow children to play in gate area
or operate gate.
Do not stand in gate path or walk through
path while gate is moving.
Read owner’s manual and safety instructions.
SERIOUS INJURY OR DEATH
CLASS
CERTIFIED TO
CAN/CSA C22.2 NO. 247
CONFORMS TO
ANSI/UL-325
VEHICULAR GATE OPERATOR
HP
53382
MODEL
SERIAL
VOLTS PHASE
AMPS 60 Hz
MAX GATE LOAD
DoorKing, Inc., Inglewood, CA
15.25” 16.75”
17.75”
24.75”
Gate Frame
Class of Operation Model 9150 - UL 325 Class I, II, III, IV
Type of Gate Vehicular Slide Gates Only
Drive Sprocket Size #40 Chain
Cycles Per Hour 60 Per Hour (Installed level).
Speed Approximately 1 Ft. per Second (Installed level).
Entrapment Protection Primary - Inherent entrapment sensing system (Type A)
Secondary - Provision for connection of a non-contact sensor (Type B1)
and/or a contact sensor (Type B2).
SPECIFICATIONS
4” Minimum
1” Minimum
10.5”
Use this manual for the Model 9150 operator with circuit board 4602-010 Rev A or higher ONLY.
Chain Height:
Idler wheels in
top position.
Concrete
Pad
Concrete
Pad
WITH Convenience Open
Max. Gate Weight
Installed Level
WITHOUT Convenience Open
Max. Gate Weight
Installed Level
AmpHorsepower - Voltage - Phase
Max Gate Length
Installed Level
1/2 HP - 115 VAC Single-Phase
1 HP - 115 VAC Single-Phase
1,000 Lbs.
1,500 Lbs.
800 Lbs.
1,300 Lbs.
30 Ft.
45 Ft.
5.4
9.7
Operator
Specification
Decal
DoorKing, Inc. reserves the right to make changes in the products described in this manual without notice and without obligation of DoorKing, Inc. to notify any persons
of any such revisions or changes. Additionally, DoorKing, Inc. makes no representations or warranties with respect to this manual. This manual is copyrighted, all rights
reserved. No portion of this manual may be copied, reproduced, translated, or reduced to any electronic medium without prior written consent from DoorKing, Inc.
Note: 208/230/460/575 VAC input voltage can be connected to the
operator by installing an “Optional” High Voltage Kit (P/N 2600-266).
To Next Page
Loading...
