General Section
G 31
Specifications
CHARACTERISTICS
1 Manufacturer
2 Model
3 Capacity at rated load center kg
4 Load center distance mm
5 Power type eletric,diesel,gas,Lp-gas
6 Operator type stand-on, driver seated
7 Tire P=pneumatic,E=elastic,C=cushion
8 Wheels(x=driven) number of front/rear
DIMENSIONS
9 Lift with STD maximum fork height with rated load mm
10 two-stage mast free lift mm
11 Fork carriage ISO Class
12 Fork lengthXwidthXthickness mm
13 spacing (minimumXmaximum) mm
14 Tilt of mast forward/backward deg
15 length to fork face mm
16 width mm
17 Overall mast lowered height mm
18 dimensions mast extended height mm
19 overhead guard height mm
20 seat height mm
21 Outside turning radius mm
22 LMC
(from center of front wheel
to fork face)
mm
23 Aisle 90 degree stacking(add load length & clearance) mm
23a Aisle 90 degree intersecting mm
PERFORMANCE
24 travel,loaded/unloaded 80V km/h
25 Speeds lift,loaded/unloaded 80V mm/s
26 lowering,loaded/unloaded mm/s
28 Max. drawbar pull
loaded/unloaded
(5 min. rating)
kgf
30 Max. gradeability loaded/unloaded (5 min. rating) %
31 Steering manual/power assisted/full power
WEIGHT
32 Total weight(with minimum weight of battery) kg
33 Axle load with load(front/rear) kg
34 without load(front/rear) kg
CHASSIS
35 number of front/rear
36 Tire Size front
37 rear
38 Wheelbase mm
39 Tread front/rear mm
40 Ground clearance at the lowest point mm
41 (unloaded) at center of wheelbase mm
42 Service brake
43 Parking brake
DRIVE
44 Battery Type
45 (80V) Max capacity/5 hours Ah
46 Weight (Minimun) kg
47 Electric motor Drive motor(1 HR Rating) kw
48 (80V) Hyd. motor(15% Duty) kw
49 Speed control with electric drive Type
50 Relief pressure system/attachment Ꭰ/
51 Noise level Leq dB(A)
G