Doosan BC30S-5 - Operation Section; Operators Station and Monitoring Systems

Operation Section
G 45
Operator’s Station and Monitoring Systems
Read and understand the “Safety”, “Operation” and “Maintenance” sections before operating the lift truck.
Key Switch
The key switch is located on the right side of the
steering column.
OFF - Turn the key switch to OFF (1) to
disconnect the electrical circuits.
ON - Turn the key switch the ON (2) to
connect the electrical circuits. If the key
switch is left in the ON position when the
operator leaves the lift truck, the LCD display will
show a flashing “EE”.
The power steering pump motor is activated when
the key switch is turned to ON and the seat switch
is closed.
NOTE: The power steering pump motor will shut off
if the directional lever is left in NEUTRAL
and no control levers are actuated for
approximately six seconds.
The motor will be turned on when any
control lever is used.
Seat Switch
the seat switch is located under the operator’s seat.
OPEN - When the operator’s seat is in the
up position the electrical circuits are
disconnected.
CLOSE - When the operator’s seat is in
the down position(operator seated) the
electrical circuits are connected.
The power steering pump motor is activated when
the key switch is turned to ON and the seat switch
is closed.