General Section
G 44
Mast Abbreviations
The identification plate indicates the type of mast
installed on the lift truck when it left the factory. The
type of mast is indicated by an abbreviation.
STD - Standard Mast(single inner member, low
free lift).
FF - Full Free Mast (single inner member,
high free lift with primary cylinder).
FFT - Triple Lift Mast (two inner members,
high free lift with primary cylinder).
QUAD - Quadruple(Quad) Mast(three inner
members, high free lift with primary
cylinder).
SPEC - Special Mast, such as non-telescopic or
double mast, not within the other
classifications.
NOTE: When only a mast-type is listed on the
identification plate, a standard carriage and
forks are used.
Attachment Abbreviations (includes
Special Forks)
SC - Special Carriage-increased width, height
or outreach.
SSS - Shaft-type Sideshift Carriage.
HSS - Hook-type Sideshift Carriage(ITA).
ISS - Integral type Sideshift Carriage.
ISFP - Integral Shifting type Fork Positioner.
CW - Special Counterweight.
SF - Special Forks.
NOTE: Numbers following this abbreviation indicate
number and/or length of forks.
SS - SWS-Sideshift-Swing Shift.
RAM - Ram or Boom
ROTC - Rotating Carriage.
DBCBH - Double Cube Block Handler
HFP - Hydraulic Fork Positioner, Non Sideshift.
CR - Crane Arm or Crane Boom.
TH - Tire Handler.
CTH - Container Top Handler.
CSH - Container Side Handler
LP - Load Push Device, Non Sideshift.
LPP - Load Push-Pull Device, Non Sideshift.
C -General Clamp (other than Bale, Carton
or Roll).
BC - Bale Clamp.
CC - Carton Clamp.
RC - Roll Clamp.
LS - Load Stabilizer.
LH - Log Handler.
PWH - Pulp Wood Handler.
SS-ST - Sideshift-Side Tilt Carriage.
To Next Page
Loading...
