9.3.39. V- Belt
•
Install the V-belt on the crank pulley,
alternator pulley and water pump pulley.
•
Adjust the V-belt tension using the ten-
sion adjusting support.
9.3.40. Oil level gauge
•
Apply sealant (Locktite #262) to the bot-
tom side of the guide tube.
•
Then assemble the guide tube and oil
level gauge on the oil pan.
9.3.41. Others
•
Assemble by connecting the other oil and fuel hoses.
9.4. Breaking-in
Refer to “Breaking-in” in chapter of “Commissioning and Operation”.
- 120 -
To Next Page
Loading...
