7. Operation Tip
7.1. Periodic Inspection Cycle
- 52 -
: Check & adjust : Replace
Inspection Daily
Every Every Every Every Every
Remark
50hrs 200hrs 400hrs 800hrs
1200hrs
Check for leakage(hoses, clamp)
Check the water level
Cooling Change the coolant water
System
Adjust the V-belt tension
Clean the radiator
Check for leakage
Check the oil level gauge
Lubrication
Change the lubricating oil
System
Replace the oil filter cartridge
Check the leakage for intercooler
(hoses, clamp)
Intake & Clean and change
Exhaust the air cleaner element
System Clean the inter-cooler air fins
Clean the turbo-charger
Check the leakage fuel line
Clean the fuel strainer
of fuel feed pump
Remove sediment from fuel tank
Fuel Drain the water in separator
System Replace the fuel filter element
Check fuel Injection timing
Check the injection nozzles
Check the state of exhaust gas
Check the battery charging
Engine
Check the compression pressure
Adjust
Adjust Intake/Exhaust
valve clearance
Every
2,000hrs
Every
2,000hrs
When
necessary
When
necessary
When
necessary
When
necessary
1st
1st
1st
clean
To Next Page
Loading...
Need help?
General
