•
Lay the removed bolts orderly not to damage the threads at all and store.
Caution :
Prevent a collision between the bolt thread each other.
•
Take out the cylinder head gasket and scrap it.
•
Remove the foreign residues from the cylinder head surface and block surface.
Caution :
Try not to make any damage on the contact surfaces.
9.1.23 Oil pan
•
Remove the oil pan assembling bolts
and disassemble the pan.
•
After removing the oil pan gasket,
scrap it.
9.1.24. Vibration damper
•
Remove the vibration damper assem-
bling bolts in the reverse order of
assembling and disassemble the
damper assembly
9.1.25. Timing gear case cover
•
Disassemble the oil seal using an oil
seal removing jig.
•
Remove the cover fixing bolts
and disassemble the cover from
the timing gear case.
- 72 -
To Next Page
Loading...
