General Section
-53-
Operator's Warning and Identification Plate
Familiarize yourself with the OPERATOR’S WARNING PLATE and IDENTIFICATION, LIFT CAPACITY and
ATTACHMENT PLATES. DO NOT exceed capacity as equipped load ratings.
Operator's Warning Plate
Located on the right side of the operator's seat.
If Convenience Package Equipped
Located on the right side of the operator's seat and
overhead guard. (If Convenience Package
Equipped).
Identification, Lift Capacity and
Attachment Plate
Located on the cowl to the right side of the steering
column.
Below are abbreviations that may appear on the
IDENTIFICATION, LIFT CAPACITY and
ATTACHMENT PLATES and their meanings.
Mast Abbreviations
STD - Standard Mast (single inner member,
low free lift)
FF - Full Free Lift Mast (single inner member
with high free lift duplex cylinder)
FFT - Triple Lift Mast (two inner members)
with either low or full free lift
characteristics.
QUAD - Quadruple (Quad) Mast(with three inner
members)
NOTE: When only a mast-type is listed on the
identification plate, a standard carriage and
forks are used.
To Next Page
Loading...
