EasyManua.ls Logo

Doosan D20S-7 - Page 72

Doosan D20S-7
247 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation Section
-69-
About MP3/WMA
This unit can play MP3 (WMA) files with .mp3, .wma
(Iower case letters) or .MP3 and .WMA (capital
letters) file name extensions.
This unit can display ID3 Tag (Version 1.0, 1.1, 2.2,
2.3 or 2.4) information for MP3 files. such as the
album name and the artist.
This unit can recognize the Korean and English
characters.
This unit can play MP3/WMA files meeting the
conditions below;
- Bit rate: 8 kbps - 320 kbps / VBR for MP3
- Sampling frequency:
48 kHz, 44.1 kHz, 32 kHz
(for MPEG-1 Layer 2/3)
24 kHz, 22.05 kHz, 16 kHz
(for MPEG-2 Layer 2/3)
This unit can recognize total of 9,999 files, of 256
folders, and 7 stages of folder structure.
This product can play MP3 files using VBR. When
playing an MP3 file of this VBR type, the remaining
time displayed may be different from the real time.
Handling precautions for USB device
When using the external USB device, make sure to
keep the device disconnected and connect only
sometime after turning on the vehicle ignition. The
USB device may be damaged if the USB device
already connected when the ignition is turned on.
(USB device is not an electronic automotive
component).
Some USB devices may not operate properly
because of compatibility issues. Check that the
external device is supported by the device before
stating use.
The device will only recognize USB devices
formatted in FAT 16/32.
When formatting the external USB device, the
device may not properly recognize a Byte/Sector
selection other than 512 Bytes or 2,048 Bytes.
Avoid the contact of bodily parts and foreign
substances with the USB connector.
Repeatedly connecting/disconnecting the USB in a
short period of time may cause damage to the
device.
When disconnecting the USB, an abnormal sound
may occur occasionally.
Abruptly disconnecting the external USB device
while the USB is operating may cause the device to
be damaged or function abnormally. Make sure to
disconnect the USB device only after the audio
power is turned off or when the audio is operating in
a different mode.
The amount of time required to recognize the
external USB device may differ depending on the
type, size, or file formats stored on the USB. Such
differences in the required time are not indications of
malfunction. Please wait the period of time required
to recognize the device.
The device support only USB devices used to play
music files.
Do not use the USB I/F to charge batteries or USB
accessories which generate heat. Such acts may
lead to deteriorated performance or damage to the
device
The device may not recognize the USB device if
separately purchased USB hubs and extension
cables are being used.
In the case of high capacity USB devices, there are
instances where the logical drives are partitioned for
user convenience. In this case, it will only be
possible to play the USB music in the top level drive.
When using partitioned drives, save the songs you
wish to play on the device only in the top-Ievel
logical drive. In addition, certain USB devices are
configured with a separate drive used to install
application programs and it may not be possible to
play songs from such drives for the reasons as
described above.
The device may not support normal operation when
using formats such as HDD Type, CF, or SD
Memory.
The device will not support files locked by DRM
(Digital Rights Management).

Table of Contents

Related product manuals