Operation Section
-77-
Changing LP Tanks
WARNING
Only trained, authorized personnel should fill or
exchange LP tanks.
Personnel engaged in filling of LP containers
should wear protective clothing such as face
shield, long sleeves and gauntlet gloves.
Do not refuel or store LP powered lift trucks
near any underground entrance, elevator shafts
or any other place where LP could collect in a
pocket causing a potentially dangerous
condition.
Examine all LP containers before filling and
again before reuse, for damage to various
valves, liquid gauge, fittings and hand valve
wheels.
All defective or damaged LP containers must be
removed from service.
Explosive fumes may be present during
refueling.
Do not smoke in refueling areas.
Lift truck should be refueled only at designated
safe locations. Safe outdoor locations are
preferable to indoor locations.
Stop the engine and get off the lift truck during
refueling.
The careless handling of LP containers can
result in a serious accident.
Use extreme care when transporting containers
to prevent damage to them.
Park the lift truck on level ground, with the parking
brake applied, the transmission in NEUTRAL, the
forks lowered and the engine running at low idle.
Close the fuel shut off valve at the LP tank. Run the
engine until it stops, then turn off the ignition switch
and the disconnect switch (if equipped).
Disconnect the fuel supply line.
If Swing out type LP-Cradle Equipped
Loosen the retaining clamps and remove the tank.
Check the mounting to be sure the locating pin
(dowel) is not missing or broken.