•
Apply engine oil to the entire face of the
tappets and slide them into the tappet
holes on the cylinder block.
•
Wet the cam bush inside diameter and
camshaft with oil, and carefully assemble
them while turning the camshaft.
Caution :
Be careful not to generate a damage to
camshaft and bush.
•
Check to see that the camshaft rotates
smoothly.
9.3.5. Crankshaft
•
Install the main bearing (refer to assemble
sequence : right figure) machined with
two holes in the cylinder block so that
the key is aligned with the key groove,
then apply oil to the bearing surface.
- 98 -
To Next Page
Loading...
Need help?
General
