•
Heat the crankshaft gear for at least 10
minutes to 120
˚C
, then apply sealant
(Loctite # 641) to the inside wall of the
heated crankshaft gear evenly before
inserting it to the end of crankshaft.
•
Semi-tighten a bolt at both sides of the
crankshaft, apply engine oil to journals
and pins, then assemble the crankshaft
with the cylinder block by tightening the
fixing bolts.
Caution :
Coat engine oil to the pin and journal of
crankshaft.
•
Install the oiled thrust washers with the
oil groove facing outward.
•
Install the bearing and thrust washers to
the bearing cap and apply oil to the
bearing and thrust washers.
- 99 -
To Next Page
Loading...
Need help?
General
