Dormakaba ED50 - Table of Contents

2 ED50/ED100/ED250 11-2022DL4616-004
dormakaba ED50/ED100/ED250 operators – Fine cover
Installation Instructions
Table of Contents
Table of contents 
 General information 
. General information 
 Product overview 
. Maximum door weights and door
installation 
. Single door configuration examples 
. Double door configuration examples 
. ED operator 
. ED/ED operator 
. Accessory terminals, guide pin, backplate
screw kit 
. Kit, ED operator labels 
. Fine cover kits 
. Fine cover kit hardware 
. Axle extensions, ED/ED/ED 
. Push arm door stop - option 
. Push arm kits 
. Pull arm kits 
. Arm screw kits 
. Optional key switch panels 
. Double door ED/ED/ED
operator connection cables 
 Technical data 
. ED/ED/ED operator technical
data 
. Operating specifications – ED/ED 
. Operating specifications – ED 
. Torque overview; ED/ED 
 Terminal board interfaces 
. ED/ED/ED terminal board
interfaces 
 ED/ED/ED door signage 
. ED/ED fulll energy operator –
ANSI/BHMA A. 
. ED/ED/ED low energy
operator – ANSI/BHMA A. 
. Safety label, automatic swing doors 
. Safety label, low energy swing doors 
. Door signage, full energy single swing
door 
. Door signage, low energy swing door 
. Door signage, full energy double door 
. Door signage, full energy double egress
door 
. Door signage, low energy double doors 
 Recommended tools and torque chart 
. Recommended tools 
. Standard tightening torque 
. Drill bits 
Table of contents
 Installation templates 
. ED/ED/ED installation
templates 
 ED/ED/ED operator
installation 
. Installation preparation 
. Remove mounting plate from
ED/ED/ED operator 
. Customer  Vac connection to
mounting plate terminal block 
. Mounting plate attachment to jamb or
wall 
. Connect customer  Vac to mounting
plate terminal block 
. Route accessory wiring to mounting plate 
. Remove protective film strips from
operator 
. Install ED/ED operator onto
mounting plate 
. Install ED operator onto mounting
plate 
 Push arm installation 
. Push arm installation templates 
. Push arm installation 
 Pull arm installation 
. Pull arm installation 
. Pull arm assemblies 
. Pull arm hardware 
. Install hardware into track 
. Assemble slide shoe 
.6 Assemble deep pull arm (DK-X
arm assembly), if used 
. Deep pull arm installation 
. Standard pull arm installation 
 Operator spring tension 
. Set ED/ED/ED operator spring
tension 
 ANSI/BHMA standards 
. ANSI/BHMA A. Power operated
pedestrian doors 
. ANSI/BHMA A. Low energy power
operated doors 
 Install door signage 
. Install door signage 
 Fine cover, end caps and spindle caps 
. Fine cover end cap and spindle installation 