ES 200 EASY PLUS
—
5
5. Maintenance and care
Maintenance
Maintenance work is to be carried out only when the
system is de-ernergized (pull the power plug).
The door system is to be tested and maintained, if
necessary, at least once a year by a specialist.
The testing and approval must be carried out according to
the test book by a person trained by DORMA.
The results are to be documented and to be retained by the
operator for at least
1 year.
We recommend to enter into a maintenance contract
with DORMA.
For more information go to
www.dorma.com.
The following parts are wear parts and need to be checked
at least once
a year and replaced, if necessary (see installation
instructions).
End stops
2
Guide rail
3
Battery pack ES200 cpl., order no. 04000160
4
Drive belt
5
Guide rollers
6
Caster
Use only original spare parts.
Care
Turn the program switch during the cleaning to the
OFF position or PERMANENT OPEN position in order
to prevent
unintended movements.
Never let water or other other liquids enter the drive
unit.
Never insert a metal object into the openings of the
drive unit. Otherwise, there will be the risk of an
electrical shock.
Clean the entire door system (aluminium, glass, cover) with a
moist cloth and common cleaning agents.
Do not use any scrubbing agents as they might damage the
surface.
Keep the floor guide rail clean at all times.
Replacing the battery
Always note the warning on batteries.
Use only recommended batteries approved by DORMA
The battery may be replaced only by qualified persons.
Refer to the installation manual.
The removal of the battery pack is carried out in the reverse
order of the installation manual.
2
3
4
5
6 6
To Next Page
Loading...
