Dormakaba SVP User Manual

5.6 Parameterization
The parameters are set from the inside of the door in
its installed state. The switches in the door lock are
operated with a door handle or key.
Symbol Operating method
To start parameterization or to
save changed parameters:
Turn the door key in the locking
cylinder in the unlocking direction
until it stops and hold it there for
at least 10s.
Symbol Operating method
To jump from one selection to the
next:
Turn the door key briefly in the
locking cylinder in the unlocking
direction until it stops.
To jump from setting to setting
within a selection:
Briefly press down the door handle
until it stops.
Fig. 30
*
*
Operation
mode
DCW®-
address
CAN
address
Terminating
resistor
* only with SafeRoute components
with the “Multi-door” license
Start End
Off
On
Flow chart
16
SVP/SVZ door locks
2020-03
WN 059744 45532
dormakaba Mounting instructions Parameterization (SVP2000/2000F only)

Dormakaba SVP Specifications

General

Operating Temperature	-20°C to +60°C
Material	Stainless Steel
Emergency Exit Function	Yes
Backset	Varies by model
Standards	EN
Power Supply	24 V DC
Voltage	24 V DC
Current Consumption	Varies by model
Holding Force	Varies by model
Door Thickness	Varies by model
Weight	Varies by model
Finish	Stainless Steel
Fail-Safe/Fail-Secure	Fail-secure (power-to-release)