Doro 6038 - Sound & Display; Audio Setup; Tone Setup (Ringtone)

English
Note! You can transfer files using a USB cable on most devices and
operating systems supporting a USB Mass Storage interface.
Disconnect the USB cable safely
1. Make sure to enable the hardware to be safely removed.
2. Disconnect the USB cable.
Note! Computer instructions may vary depending on your operating
system. See the documentation of your computer's operating system for
more information.
Sound & Display
Note! Silent needs to be set to Off to access Tone setup, Volume, Alert
type and Extra tone.
Audio setup
If you use a hearing aid or have hearing difficulties when using the device
in a noisy environment, you can adjust the audio settings.
1. Press Menu � Settings � Sound � Audio setup:
• Normal for normal hearing in normal conditions (default).
• High for moderate hearing impairment or use in a very noisy
environment.
• HAC mode for use with hearing aid.
2. Press Ok to confirm.
Note! Try different settings to find the one that suits your hearing the best.
Tone setup (ringtone)
Select a ringtone with the best tone curve adjustments and frequencies to
best fit your needs.
1. Press Menu � Settings � Sound � Tone setup � Ringtone.
2. Use
/ to select one of the available melodies, the melody is
played.
3. Press Ok to confirm or Back to discard changes.
Tip: Set up the Alarm, Message tone, Keypad tone, Power on and Power
off in the same way.
37