Doro CARE - Alarm Operation Explained; How the Alarm Works

9
DORO CARE FOR TECHNICAL HELP SEE PAGE 10
HOW THE ALARM WORKS
No Mode Explanation Setting
1 STANDBY Alarm not activated
2 ALARM Pressed. The unit will wait the 0 or 10 seconds can
selected time before the alarm will be be selected
activated. Press and hold STOP to
stop the alarm function.
3 ALARM The phone will connect to the line and The number will be
ACTIVATED dialed, after 60 or 180
DIAL M1 seconds if there is NO
dial the stored number in position M1.
reply, the next
number will be dialed.
4 THE The called number will hear the voice Voice message or
CALLED message several times. They can now tone can be selected.
TELEPHONE press:
NUMBER IS # to connect the speaker phone
ANSWERED function
and/or
* to turn off the alarm.
5 DIALS If there is no response upon dialling
M2, M3 &
M4...
M1, the telephone will dial the
following numbers in the call list M2,
then M3 etc.
6 REPEAT The telephone will dial the numbers in 14 times or unlimited
THE CALL can be selected.
LIST
the call list in turn (M1, M2, M3 &
M4).
7 STANDBY The alarm is not activated