3
DORO CARE
BATTERIES
The unit requires 6 x 1.5V AAA batteries (supplied). Use only good quality Alkaline
batteries.
The unit will NOT function during power failure if backup batteries are not installed.
# Ensure the telephone line cord is not connected to the network wall socket.
# Remove the retaining screw securing the battery cover on the underside of the unit.
# Insert the backup batteries observing correct polarity, and refit the battery cover.
Remote alarm button requires 1 x 12v type 23A (supplied). Use only a good quality
Alkaline battery.
# Remove the battery cover by carefully sliding it out.
# Insert the battery observing correct polarity, and refit the cover.
IMPORTANT!
If the backup batteries are almost discharged (or not connected) the battery
indicator will begin to flash. Change the backup batteries immediately.
CONNECTING
# Connect the line cord to the outlet socket marked LINE and the other end to a
telephone wall point.
# Connect the curly cord to the socket on the left hand side of the telephone, and to
the handset socket.
# Connect the power adaptor (PSU) to the socket marked POWER, and the other
end to a mains power point, switch on the mains power.
# Ensure Earpiece volume is set to minimum. Lift the handset and check if there is
dial tone, adjust the earpiece volume as required.
HEARING AID COMPATIBLE
The DORO CARE is hearing aid compatible. Switch your hearing aid to the T
position.
LOCATING THE TELEPHONE
# The DORO CARE should if possible be connected to your network master socket.
# Do not locate the telephone near TV’s, computer monitors, etc. This is to eliminate
the risk of interference of the remote signal, ie NO operation.
# Do not locate the phone in direct sunlight, close to other strong heat sources or in
humid conditions.
# Ensure the mounting surface cannot easily be marked. In some rare cases the
rubber feet may cause discolouration/marking.
To Next Page
Loading...
