English
Installation
This device is intended for the analogue telephone network lines in AT,
BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU, IE, IS, IT, LV, LT,
LU, MT, NL, NO, PL, PT, RO, SI, SK, SE.
Connection
1. Connect the curly cord to the handset and to the socket marked
q on the unit.
2. Connect the mains adapter to an electrical wall socket and then to
the socket marked DC 9V/300mA on the unit.
3. Connect the telephone line cord to a network wall socket and then
to the socket marked K on the unit.
4. Lift the handset and listen for the dial tone.
Note! Use supplied telephone line cord, an existing cord from a previous
phone may not be compatible.
Batteries
The unit is powered with the provided mains adapter and has batteries
as backup in the event of a power cut. 4 AA alkaline batteries are needed
for full functionality in the event of a power cut. Typical backup time, 15
hours with new batteries. When
is displayed, replace all 4 batteries.
Use only AA alkaline batteries of good quality (not included).
Note! Before installing or changing the batteries, make sure that the
phone is not connected to the telephone network.
1. Remove the battery cover and insert the batteries ensuring correct
battery polarity is observed.
2. Replace the battery cover and reconnect the telephone line cord.
To Next Page
Loading...
