EasyManua.ls Logo

dosatron D 25 RE 2 - Installation Hints and Flow Management; Filter Requirement for Warranty Validity

Default Icon
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
©
DOSATRON INTERNATIONAL / 12
©
DOSATRON INTERNATIONAL / 12
INSTALLATION HINTS
EXCESSIVE FLOW (as an indication)
If your DOSATRON clicks more than 40 times, that is 20 cycles in 15 seconds*,
you are close to the maximum flow limit. If you need more flow, you must
install a DOSATRON with a higher capacity of flow.
*D 25 RE 10 = 30 times, 15 cycles
The DOSATRON can be connected to
the main water line directly (Fig. 4) ;
on a by-pass (Fig. 5), recommended.
If your flow rate is above the opera-
ting limits of the DOSATRON, see
EXCESSIVE FLOW.
To prolong the working life of the
DOSATRON it is advisable to install a
filter (ex.: 300 mesh - 60 microns depen-
ding on your water quality) upstream.
This is imperative if the water contains
impurities or particles, especially if the
water comes from a well.
A filter is recommended and requi-
red for the warranty to be valid.
Installing the DOSATRON on
a bypass enables clean water to
be supplied without operating the
DOSATRON and the DOSATRON to
be easily dismantled.
When connecting an
installation to the public
water supply, you must res-
pect the rules and regulations
in force in the country.
Fig. 4
Check
valve
Valve
Valve
Filter
Filter
Fig. 5

Related product manuals