XMPI0MTIRPD2ST021 14/24 Ed. 2021
D009 – OUTPUTS
Engine revolutions
per minute
The layout of the outputs is as shown in the table below. Digit 1 is the one furthest to the right. For output
status, 0 = OFF, 1 = ON.
Engine revolutions
per minute
D100 – NUMBER OF ERRORS STORED
Engine revolutions
per minute
D101 – D105 – LAST FIVE ERRORS OCCURRED
In these menus, D101 to D105, the codes of the last 5 errors occurred will be displayed. For further details,
please refer to the chapter "Diagnostics and troubleshooting".
D140-D141- ROOT PASSWORD
The root password is a 4-digit numerical password which, once set, allows access to and modification of the
parameters in the setup menu to be blocked.
Parameter D141 allows the password to be set. Once a password other than 0000 has been set, access to the
settings menu is blocked. In order to access and modify the parameters, the password must be entered in
D140. If the root password is set, the display of parameter D141 is protected until the password is entered
again on D140.
Output 2 not available on all models.