Doseuro Rapida 2.0 - Connection Diagrams; Display Board Layout

XMPI0MTIRPD2ST021 20/24 Ed. 2021
11 CONNECTION DIAGRAMS
ATTENTION: the version with graphic panel display is supplied with all the necessary connections already
made. You only need to read this chapter if you need to reconnect the display to the inverter.
11.1 DISPLAY BOARD LAYOUT
FIGURE 1
Key:
1
JST power connector
9
Reserved for special applications
2
AMP MOD II power connector
10
Reserved for special applications
3
Pin Header 5x2 inverter-display communication
11
WiFi antenna
(1)
4
RS485 serial auxiliary connection
12
WiFi Mesh addressing jumper
5
RS485 serial auxiliary connection
13
Reserved CANBUS connector
(2)
6
Reserved for special applications
14
Reserved CANBUS connector
7
Reserved for special applications
15
Reserved CANBUS connector
8
Reserved for special applications
16
Hardware version
1
For more information on using the display with integrated WiFi, please contact our Technical Service.
2
For further information on the use of CanBus, please contact our Technical Service.