Doseuro Rapida 2.0 - Setup Menu

XMPI0MTIRPD2ST021 15/24 Ed. 2021
If the display is password-protected and unlocked, access to the setup menu will be automatically locked again
after one minute of inactivity on the keys.
To remove the root password, simply reset parameter D141 to 0000.
D150-D151- USER PASSWORD
Same principle as D140-D141, with the difference that this password blocks access and modification of the
user setup menu. The same rules as for parameters D140-D141 apply.
D199 - PUMP SERIAL NUMBER DISPLAY
This parameter allows the serial number of the machine to be displayed.
D200 - PARTIAL HOUR COUNTER – Hours and tenths of hours
H. meter. P.
0066.7
Pressing and holding the SEL button for 5 seconds will reset the partial hour meter.
D201 – TOTAL HOUR COUNTER – Hours and tenths of hours
H. meter. T.
0566.7
8. SETUP MENU
1
PARAMETER
DESCRIPTION
VALUES
UNIT OF
MEASURE
DEFAULT
S001
TOTAL FLOW
2÷6000
l/h
2
S002
NUMBER OF PULSES/HOUR
2÷60000
-
9367
S003
REDUCTION RATIO (INPUT PULSES)
0.10÷999
-
1.00
S004
ENABLING PULSE COUNTER MODE
ON÷OFF
-
OFF
S005
LINE Q ADJUSTMENT (FLOW RATE) SECTION 0÷10 Hz
-20÷20
%
0
S006
LINE Q ADJUSTMENT (FLOW RATE) SECTION 10÷20 Hz
-20÷20
%
0
S007
LINE Q ADJUSTMENT (FLOW RATE) SECTION 20÷30 Hz
-20÷20
%
0
S008
LINE Q ADJUSTMENT (FLOW RATE) SECTION 30÷40 Hz
-20÷20
%
0
S009
LINE Q ADJUSTMENT (FLOW RATE) SECTION 40÷50 Hz
-20÷20
%
0
S010
LINE Q ADJUSTMENT (FLOW RATE) SECTION 50÷60 Hz
-20÷20
%
0
S011
INPUT 1 CONFIGURATION (8.1)
N.O./N.C.
-
N.O.
S012
INPUT CONFIGURATION 2 (8.2)
N.O./N.C.
-
N.O.
S013
INPUT 3 CONFIGURATION (8.3)
N.O./N.C.
-
N.O.
1
This menu is configured at the factory during testing and is not accessible to the user