Doseuro Rapida 2.0 - Detailed Description of the Main Registers

XMPI0MTIRPD2ST021 16/24 Ed. 2021
S014
INPUT CONFIGURATION 4 (8.4)
N.O./N.C.
-
N.O.
S015
BEHAVIOUR IN CASE OF ERROR ON IN.3
STOP/RESTART
-
RESTART
S016
BEHAVIOUR IN CASE OF ERROR ON IN.4
STOP/RESTART
-
RESTART
S017
ERROR IN CASE OF SENSOR FAILURE
ON/OFF
-
ON
S018
PARAMETER DISPLAYED AT SWITCH-ON
1÷202
-
1
S019
MAXIMUM INVERTER MOTOR TEMPERATURE
45÷80
-
80
S020
UNIT OF MEASURE
°C,L/h or °F, gal/h
-
°C,L/h
S021
COUNTER MODE
Up/Down
-
Down
S022
ANALOGUE INPUT CONFIGURATION
4-20mA or 0-10V
-
4-20mA
S023
MAXIMUM FREQUENCY
25÷60
Hz
60
S024
ACCELERATION RAMP
0.5÷60
s
1
S025
DECELERATION RAMP
0.5÷60
s
0.35
S026
PWM MODULATION FREQUENCY
2.5-5-7.5-10-12.5-15
kHz
5
S027
MAXIMUM CURRENT (I)
1
0÷8
A
-
S028
ERROR RESET
Skip/Reset
-
Skip
S029
SERIAL NUMBER SETTING
-
-
-
S030
MOTOR VOLTAGE
110÷230
V
230
2
S031
V. CONST.
Enabled/Disabled
-
Disabled
S099
RESET TO DEFAULT VALUES
43
-
43
8.1 DETAILED DESCRIPTION OF THE MAIN REGISTERS
S001 – TOTAL FLOW RATE – Allows the flow rate to be changed according to the pump connected. Changing
this parameter allows the times to be displayed correctly.
S002 –S003 – S004 – PULSE MODE – Changing these parameters enables and changes the pulse mode that
can be used in the dosing mode. For more information see the chapter on operating modes.
S005 - ADJUSTMENT OF LINE Q (FLOW RATE)
SECTION 0÷10 - By modifying this parameter it
is possible to change the values of the flow rate
as a function of frequency for the range of the
Q line from 0%÷10%.
S006 - ADJUSTMENT OF LINE Q (FLOW RATE)
SECTION 10÷20 - By modifying this parameter
it is possible to change the values of the flow
rate as a function of frequency for the range of
the Q line from 11%÷20%.
S007 - ADJUSTMENT OF LINE Q (FLOW RATE)
SECTION 20÷30 - By modifying this parameter
it is possible to change the values of the flow
rate as a function of frequency for the range of
the Q line from 21%÷40%.
S008 - ADJUSTMENT OF LINE Q (FLOW RATE) SECTION 30÷40 - By modifying this parameter it is possible to
change the values of the flow rate as a function of frequency for the range of the Q line from 41%÷60%.
1
0.18-0.25kW = 3A; 0.37-0.55kW = 4A; 0.75kW = 8A
2
May vary for special motors/voltages