10
1 OPERATION
DECALS
WARNING DECAL REQUIREMENTS
When your compactor leaves the factory, several WARNING DECALS are installed for your
protection. These labels are subject to wear and abuse due to the nature of operation.
The FOLLOWING DECALS MUST BE MAINTAINED. Additional decals may be purchased
through your distributor or from Marathon Equipment Company by either calling the parts
department at 1-800-633-8974 or going to www.parts1stop.com to place an order
online.
When ordering replacement decals, match the reference numbers in the chart below with
the drawing on the next page (and pages 13 & 14 for optional equipment or HT
models) or look for the part number in the lower right hand corner of the decal.
Part # Ref. # Description Quantity
05-0325 RIVETS, 1/8 X 1/2 ALUM (to go with 06-0364) 4
06-0038 1 WARNING DO NOT REMOVE ACCESS COVER 2
06-0039 2 DANGER DO NOT ENTER 3****
06-0067 3 D/N REMOVE CONT TIL REAR... 2
06-0072 4 QUICK CLEAN TANK 1
06-0093 5 FIRE HOSE PORT 2
06-0094 6 NOTICE WIPE OFF SEAL AFTER.... 2
06-0121 7 NOTICE FEDERAL REGULATION...NO <18 y.o. 2
06-0124 8 CYCON 2
06-0249 9 DANGER HAZARDOUS VOLTAGE 2
06-0364 10 COMPACTOR SERIAL NUMBER 2
06-1839 11 AMERICAN FLAG 3
06-0057 12 WARNING STAND CLEAR OF COMPACTOR 3
06-0002 13 RAM-JET 4
06-3123 14 CONFINED SPACE 3****
06-3231 15* ULTRA DECAL 2
06-0040 16** CAUTION: KEEP OUT ****
06-0052 17** CAUTION: GATE MUST BE CLOSED.... ****
06-0104 18*** HT OPERATING INSTRUCTIONS 1
06-0105 19*** DANGER: STAND CLEAR OF TAILGATE... 3
*ONLY ON “ULTRA” MODELS.
**ONLY ON OPTIONAL EQUIPMENT (ACCESS GATES, HOPPERS, &/OR DOGHOUSE.
***ONLY ON HT UNITS (HYDRAULIC TAILGATE).
****QUANTITY VARIES DEPENDING ON OPTIONAL EQUIPMENT, NOTE QUANTITY ON MACHINE.
To Next Page
Loading...