3
1 OPERATION
INTRODUCTION
THANK YOU FOR PURCHASING A MARATHON
SELF-CONTAINED COMPACTOR/CONTAINER.
This compactor is designed to give you reliable and superior performance for many
years to come. The purpose of this manual is to provide the owner and operator with
the necessary information to properly and safely install, operate, and maintain your
self contained compactor. Also included are sections regarding troubleshooting and
service procedures. The manual is not intended as a primary training source, but as a
reference guide for authorized, trained personnel. Each person involved in the
operation, maintenance and installation of the machine must read and thoroughly
understand the instructions in this manual and follow ALL WARNINGS.
The employer involved in the operation, maintenance, and installation of the
compactor must also read and understand the most current version of the following
applicable standards:
ANSI Standard No. Z245.2, “Stationary Compactors Safety Requirements”
A copy of this standard may be obtained from:
ANSI
25 West 43rd Street
New York, NY 10036
OSHA 29 CFR, Part 1910.147
“The control of hazardous energy (lockout/tagout)”
Any service or repair instructions contained in this manual should be performed by factory
authorized personnel only. If you should need assistance with your baler, please contact your
distributor.
When contacting your distributor, you will need to provide:
Compactor Serial Number:___________________________
Installation Date:______________________________
Electrical Schematic Number:____________________
IF YOU HAVE ANY SAFETY CONCERNS WITH EQUIPMENT, OR
NEED FURTHER INFORMATION, PLEASE CONTACT US AT:
Marathon Equipment Company
Attn: RamJet
®
Service Department
P.O. Box 1798
Vernon, Al 35592-1798
1-800-633-8974
To Next Page
Loading...