25
The format characters are:
Placeholder character
Description
# Stands for the next data character of the input data
&
Stands for all remaining data characters in the input
data
^
Stands for the next check digit (use only if check
digits will be computed)
A
Switch to Subset A (used in: Code 128, EAN 128,
UCC 128) Start- or stop character A (only in:
CODABAR)
B
Switch to Subset B (used in: Code 128, EAN 128,
UCC 128) Start- or stop character B (only in:
CODABAR)
C
Switch to Subset C (used in: Code 128, EAN 128,
UCC 128) Start- or stop character C (only in:
CODABAR)
C
Enable compatibility mode for CAPTIVA/IBML
document scanning software (used in Data Matrix
only)
D
Start- or stop character D (only in: CODABAR),
Only for Pharmacode: encode the Pharmacode
directly (bar by bar)
Only for Data Matrix: use an alternative error
correction algorithm for symbols of size 144x144.
E
Translate the Escape Sequences that the input data
contains.
S
Only for MaxiCode: enables setting the values of
Date, Preamble, Service Class, Postal- and Country-
Code directly in the barcode data (only in conjunction
with escape sequences).
<
Adds quiet zone markers at the left (“<”) and/or at the
right (“>”) side of the barcode. These markers are
supported by the following barcode types:
EAN8 and add-on variants (both sides)
EAN13 and add-on variants (only right side)
UPC-A with 2 and 5 digit add-on (only right side)
UPC-E with 2 and 5 digit add-on (only right side)
ISBN (only right side)
J
Enables formatting of Japanese postal code data for
JPN 4 state barcode.
To Next Page
Loading...
