40
The screen above shows the data for four fields loaded correctly. The record
number is indicated in the left hand column. The data that will be loaded into [Field 1] on
any object in a layout in the current job is listed here.
Selecting “Print Selected Rows Only” will put the data grid into select mode so that
whatever rows are pressed will be selected. When the job is printed, only the data from
selected rows will be used to print.
If “Start from first Selected Row” is selected, then when printing is started, the data
used will be used starting from the first selected row.
Enter a record number and select Go To Record to move to that record in the
loaded database.
It is not possible to edit data in this view. If it is desired to print a subset of data, it
should be done by selecting “Print Selected Rows Only” and selecting the desired data.
If “Allow Reprints” is not checked in the Data Source selection screen, the “Print
Selected Rows Only” and “Start from first Selected Row” will not be enabled.
Press the
(Ok) button.
To Next Page
Loading...
