1.8 Installation Rack Monitor 88XX
Installation & maintenance shall be carried out in accordance with the applicable code of practice by suitable
trained personnel.
Steps to mount the Rack Monitor 88XX:
• Remove the Rack Monitor 88XX from the box and make sure it is free from damages,
• Check if the Rack Monitor 88XX corresponds to the drawing in Figure 2.
Figure 2
• Remove the 14 bolts mounted into the lid,
• Remove the lid and pay extra attention to the plastic
screen mounted on the rear of the lid.
The plastic screen is part of the flame-path of the
housing,
Warning: Store the lid on a clean surface with.
Front faced downwards.
Mounting Holes
Drawing at right shows the dimensions
of the mounting holes
Figure 3
To Next Page
Loading...
