Rack Monitor 88XX
Document: Installation Manual
Date: January 2024
Version: A.0 subject to change
Page 27 of 30 – Installation Manual
Annex A - Available detail wiring drawings of the Rack Monitor
88XX and associated parts
Drawing(s)
Annex B - Recommended Spare Parts
With the purchase of the Rack Monitor the OPW Engineered Systems recommends some spare parts to be
purchased. Although this Rack Monitor 88XX is designed with solid state lamps and minimum maintenance
components spare parts are available.
When parts are replaced it is recommended to replace them with the original parts.
The recommended spare parts are:
Mains power input fuse (TR5 1A Slow Blow 250V), Qty. 2 per unit)
Relay contact output fuse (TR5 2A Slow Blow 250V), Qty. 3 per unit)
Corrosion protector silica gel 8800XX
The following parts are also available:
Internally used connector kit
Blue Function key (low level)
Red Function key (high level)
Fastener kit 14x Door Bolts
Operation manual, OPW Engineered Systems
Cable gland M20x1,5 Ø cable diameter 10-14mm ATEX-Ex/d (not armed)
Cable gland M20x1,5 Ø cable diameter 3.1-8.6mm ATEX-Ex/d (not armed)
Black Plug and 10-conductor individual screened coiled cable.
Rack Monitor Test Equipment
An Automatic Rack Tester 1386E can be used to test the rack monitor and cable. Rack Monitor tester 1386-1386 is
also available and may be used as well for testing / commissioning. Ask OPW Engineered Systems for availability.
To Next Page
Loading...
