The following applies:
• All incidents must be reported to OPW Engineered Systems. In case of injudicious use or if a calamity has
occurred, the complete installation / construction needs to be inspected according to the maintenance
instructions.
• It is prohibited for unauthorized people to be in the near proximity of the Rack Monitor 88XX. Especially
when the Rack Monitor 88XX is in use, only the operator is authorized to be in the working area of the Rack
Monitor 88XX.
5 Dismantling Rack Monitor
Attention: Dismantling must be performed by authorized and trained personnel only.
At the end of it’s lifetime and/or when changings the infrastructure of the working environment the rack Monitor
88XX must be moved to a new location the rack monitor should be dismantled.
Attention: The same precautions and procedures of initial installation should be followed.
Warning: Ensure a safe working environment prior to installing or dismantling. In case of a
hazardous environment such please ensure cleaning the parts. When in doubt consult
specialized personnel, companies or governments.
Before dismantling the rack monitor, please take following precautions;
• Make sure to use adequate PPE (personal protection equipment) at all times during the operation.
• Arrange necessary permits and/or approval with the responsible company representatives prior to starting.
If rack monitor is cleaned and dried and the required precautions are taken it can be dismounted.
• Dismount the bolts from the door of the Rack Monitor 88XX.
• Remove lid.
• Disconnect all cables.
• Dismount the bolts from the connecting plate between the rack monitor and the Stand Post.
• Remove the rack monitor.
Warning: When removing the last bolt, make sure that is doesn’t fall onto the ground, if necessary, put
straps around it and use a hosting device to lift the Rack Monitor 88XX.
• Secure the parts from moving by securing them with the bolts from the door (use at least 2 bolts and send
the remaining back separately),
Or
• Take the rack monitor apart by disconnecting all the parts,
• Remove all the parts,
• Dispose the parts separately, so the parts can be recycled,
Or
• Send the Rack Monitor 88XX back to OPW Engineered Systems
Please make yourself aware of potential risks when disassembling the rack monitor. Please consult qualified
personnel or contact local reseller / companies, local governments or OPW Engineered Systems.
To Next Page
Loading...
