11
7. WARNING MESSAGES
7.1 OPENING MESSAGE
When plugging the oven in, some information on the type of the oven and other technical
parameters will appear during a few seconds. Those informations are not for the use of the
user.
7.2 COLD VAPOR MESSAGE
If there is a need for vapour, the button should be pressed until the pilot light is
turned on. At this time, the steam generator will heat until it reaches the temperature set
by the manufacturer.
When the steam button is intermittent, this means that the steam temperature is not
correct. When the pilot light goes off, it means that the cooking can start. When the
temperature is correct light goes out indicating that you can start cooking.
The user can see what is the steam temperature by pressing the button for 2
seconds. The steam temperature is shown on the upper display for 30 seconds.
7.3 END OF COOKING
When the cooking begins, the cooking timer will countdown each minute until it reaches
0. When the timer reaches 0, a warning indicating the end of the cooking time will appear.
The warning indicating the end of cooking is intermittent and will remain so for the
period of time. If the user presses any button during the warning, it will stop.
Once the cooking time has ended, and if the cooking cycle has not been interrupted by the
user, the cycle counter will continue counting the time that is added on to the cooking
time. The clock display will remain intermittent indicating this situation.
At 2,4,6,8,10 minutes, added to the cooking cycle, the panel sends out a warning with a
brief intermittent buzzer. At 10 minutes the cycle is automatically stopped.
7.4 BREAKDOWN MESSAGES
A breakdown produces a continuous warning in one of the displays, and activates the
alarm relay until the fault is acknowledged by pressing any key. At that moment the
warning relay is deactivated, and the message continues to show on the display until the
fault is repaired. Breakdowns disconnect all control outputs warning.
To Next Page
Loading...
