A-8
FC16
To reverse the direction of the conveyor on FC16 oven, open the back panel of the oven (picture A).
Disconnect the red [A+] and black [A-] wire (picture B) of the conveyor motor on the electronic
board and invert the two wires (picture B). The conveyor should run in the other direction.
To reverse on some models with the optional directional switch, change the position of the conveyor
switch (picture C) located beside the conveyor motor from position [ I ] to [ II ] or [ O ] for not
operational conveyor.
INSTRUCTIONS TO REVERSE DIRECTION OF THE CONVEYOR
C
A
B
To Next Page
Loading...
