A-34
TROUBLESHOOTING
BEFORE CALLING FOR SERVICE
ANSWERS TO MOST FREQUENT QUESTIONS
Questions Solutions
The oven is "ON", but does not function.
! Check the main breaker (the one on the building
panel) and also the breaker located at the front of
the oven (5 amps).
! On FC18 oven, check if the emergency stop
switch located at the front of the oven is pulled
out.
The fan runs but the oven does not heat.
The red light on the front control panel is
on and the alarm ring.
! Check if the thermostat is adjusted high enough
to fire the oven.
! Check the main gas valve.
! To start it over, press the red button on the front
control panel for 2 seconds. The burner will start
up (you can hear it). You can repeat this
operation three times. If it does not start up again,
contact our company or a certified gas technician.
The oven heat too much or does not
produce enough heat.
! Measure the temperature with an oven
thermometer and compare it with the temperature
indicated on the thermostat.
The conveyor chain is not tight enough.
! To tighten:Take off the protector at the end of the
speed control located on the sides of the
conveyor. With a 7/16" key, lightly unscrew the
2 screws having an adjustment on each side;
! Tighten the belt of the conveyor and the screws;
! Put back the protectors.
The conveyor does not turn.
! Check the 0.75 amps breaker on the front for
FC2 or on the side for FC18 of the oven.
! If the breaker is "tripped", check if the conveyor
is free from any obstructions before resetting the
breaker.
! Check the conveyor main shaft if the security
clutch is not slipping.
To Next Page
Loading...
Need help?
General
