Mach LED 2MC/SC
Dr. Mach
Lamps and Engineering
59160001-MCSC Edition 06 08.05.2013 / Bak page 26/34
8.2. Electrical data
Mach LED 2MC Mach LED 2SC
Power consumption 70 W 30 W
Operating voltage DC 24 V – 30 V 24 V – 30 V
Current 2,90 A 1,25 A
8.3. Information regarding the electrical installation
When turned ON, the OT-light MACH LED 2MC/SC is exposed to a current peak.
The OT-light MACH LED 2MC/SC is delivered with a Dr. Mach power supply.
It is a electronic power supply with a wide-range input, input voltage 100 – 240V AC, 50 – 60Hz, output
voltage 28V DC.
In case there is a switch-over relay needed for a emergency power supply on site, this switch over relay
must be ordered separately at Dr. Mach. Order no. 18351001.
In case of a power supply provided by the customer, the following points must be observed:
The OT-light works with 24V – 30V DC (direct voltage).
The direct voltage provided by the hospital must have a maximum undulation of 5%.
A higher voltage (28V – 30V DC) is recommended, this causes a dicrease in heat development of
the light.
8.4. Weights
Light Weight
Mach LED 2MC 13,2 kg*
Mach LED 2SC 12,5 kg*
* without handle
To Next Page
Loading...
