Mach LED 2MC/SC
Dr. Mach
Lamps and Engineering
59160001-MCSC Edition 06 08.05.2013 / Bak page 34/34
Table 6 – Recommended separation distances between portable and mobile
RF communications equipment and the EQUIPMENT or SYSTEM -
for EQUIPMENT and SYSTEMS that are not LIFE-SUPPORTING (see 5.2.2.2)
Recommended separation distances between
portable and mobile RF communications equipment and the MACH LED 2MC/SC
The MACH LED 2MC/SC is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the MACH LED 2MC/SC can help prevent electromagnetic interference by maintaining a minimum distance be-
tween portable and mobile RF communications equipment (transmitters) and the MACH LED 2MC/SC as recommended below, according
to the maximum output power of the communications equipment
Separation distance according to frequency of transmitter
m
Rated maximum output
of transmitter
W
150 kHz to 80 MHz
Pd 17,1
80 MHz to 800 MHz
Pd 17,1
800 MHz to 2,5 GHz
Pd 34,2
0,01 0,12 0,12 0,23
0,1 0,37 0,37 0,74
1 1,17 1,17 2,33
10 3,69 3,69 7,38
100 11,67 11,67 23,33
For transmitters rated at a maximum output power not listed above the recommended separation distance d in metres (m) can
be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of
the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
To Previous Page
Loading...
