36 DR
®
FIELD and BRUSH MOWER
End of Season and Storage
BEFORE PERFORMING ANY MAINTENANCE PROCEDURE, STOP THE ENGINE AND DISCONNECT THE
SPARK PLUG WIRE(S).
NOTE: Please refer to the engine owner's manual for engine-specific procedures.
• Change the oil (and oil filter, if applicable). For winter use, use SAE 5W – 30 HD.
• Remove the spark plug(s) and pour about 1 ounce of motor oil into the cylinder hole. Replace the
plug(s) and pull the recoil starter rope until you feel strong resistance. This will coat the piston and
seat the valves to prevent moisture buildup.
• Clean/replace the air filters.
• Clean dirt and debris from the cylinder head cooling fins, blower housing, debris screen and
muffler area of the engine.
• If your engine has a fuel filter, replace it.
• If your DR FIELD and BRUSH MOWER will be idle for more than 30 days, we recommend using a
gas stabilizer. This will prevent sediment from gumming up the carburetor. If there is dirt or
moisture in the gas or tank, remove it by draining the tank. Completely fill the tank with fresh,
unleaded gas and add the appropriate amount of stabilizer or gasoline additive. Run the engine for
a short time to allow the additive to circulate. Close the fuel shut-off valve, if your machine is
equipped with one, to prevent carburetor overflow and leakage.
• Store the battery in a dry area that will not freeze. If the machine is not used over a long period, the
battery should be charged every four to six weeks. See page 24.
• Remove any wrapped weeds from the blade bearing housing. Clean grass and debris from the top
and underneath the mower deck with a stiff brush.
• Check the blade for nicks and wear. Remove the blade and sharpen, or have it professionally
sharpened if needed.
• Perform the lubrication as outlined on pages 25 and 26.
NOTE: For winter use, please refer to the attachment instructions.
To Next Page
Loading...
Need help?
General
