800 HINESBURG ROAD, SOUTH BURLINGTON, VERMONT 05403
©2019 DR Power Equipment. All rights reserved A0000199395_A
Before performing any maintenance procedure or inspection on the Mower, release the blade control bail bar to stop the blades.
Shut off the engine and wait 5 minutes for parts to cool. Remove the spark plug wire, keeping it away from the spark plug and
disconnect the negative battery wire to prevent accidental starting.
Before performing any maintenance procedure or inspection on the Mower, release the blade control bail bar to stop the blades.
Shut off the engine and wait 5 minutes for parts to cool. Remove the spark plug wire, keeping it away from the spark plug and
disconnect the negative battery wire to prevent accidental starting.
Daily Checklist for the DR WIDE-CUT LAWN MOWER
To help maintain your DR WIDE-CUT LAWN MOWER for optimum performance, we recommend you follow this checklist
each time you use your Mower.
[ ] Check the engine oil level.
[ ] Check the fuel level.
[ ] Check that the blades and mounting hardware are not worn or damaged.
[ ] Check the general condition of the Mower, e.g.; nuts, bolts, welds, etc.
Cleaning the Mower
1. For best results, clean the mower soon after you have completed mowing.
2. With the engine running on a flat paved surface, spray a stream of water in front of the right rear wheel.
3. The water will splash into the path of the blade, cleaning out the clippings.
4. When no more clippings come out, stop the water and move the mower to a dry area.
5. Run the engine for a few minutes to dry the housing.
End of Season and Storage
Immediately prepare your mower for storage at the end of the season or if the mower will not to be used for 30 days or more.
See your Engine owner’s manual for detailed engine care and storage procedures.
When the mower is to be stored, remove all dirt, grease, leaves, etc.
On the last refueling of the year, add fuel stabilizer to the fuel as directed by the engine manufacturer. Run the mower until
the engine stops from running out of fuel. Prime the engine and start it again. Allow the engine to run until stops. When
you can no longer start the engine, it is sufficiently dry. Remove the spark plug, add 1 oz. (30 ml) of oil through the spark
plug hole, and pull the starter rope slowly several times to distribute oil throughout the cylinder to prevent cylinder
corrosion during the off- season.
Clean the exterior of the unit to remove all dirt, grease, and any other foreign material. To prevent rust, touch up painted
surfaces that have been scratched or chipped.
Store your mower indoors and cover it with a suitable protective cover to give protection from dust and dirt. Do not use
plastic. Plastic cannot breathe which allows condensation to form and will cause some mower parts to rust.
To Previous Page
Loading...
Need help?
General
