To Next Page

To Previous Page

 Check to make sure the operator controls are moving freely. Lubricate the Throttle Lever, PTA



Lever (SPRINT



and PRO

models), and Key Switch with SAE 30 Oil if necessary.

 If your Engine has a Fuel Filter, replace it.

 If your DR TRIMMER/MOWER will be idle for more than 30 days, we recommend using a gas stabilizer. This will prevent

sediment from gumming up the Carburetor. If there is dirt or moisture in the gas or Tank, remove it by draining the Tank.

Completely fill the Tank with fresh, unleaded gas and add the appropriate amount of stabilizer or gasoline additive. Run the

Engine for a short time to allow the additive to circulate.

 For Electric Start Model, store the machine in a dry environment with temperatures between +40°F (5°C) and +95°F (+35°C).

Make sure the storage temperatures will never be outside of these limits. The lower the storage temperature is within the

specified temperature, the better as the battery will discharge more slowly at low temperatures. If it is necessary to store the

Trimmer/Mower outside make sure to disconnect the battery and store it in an environment as listed above. Make sure the

disconnected battery terminals are not resting on any surface that may be prone to collecting water, snow or any other liquid as

this may cause damage to the terminals and to the battery when reconnected.

 Oil Chains as needed.

Other manuals for DR SPRINT

Questions and Answers:

Need help?

Do you have a question about the DR SPRINT and is the answer not in the manual?

General