Dräger Atlan A300 - Page 36

36 Instructions for use | Atlan A300, A300 XL, A350, A350 XL SW 1.0n
Overview
– Events (e.g., alarms, confirmed alarms, switch-on time and switch-off time)
–Test results
– Gas consumption
– Anesthetic agent consumption
3.2.9 Gas supply
The device can be supplied with the following gases:
3.2.10 Gas scavenging
The gas can be scavenged by means of the following procedures:
– Active anesthetic gas scavenging
– Passive anesthetic gas scavenging
Further information can be found on page 65.
3.2.11 Data exchange, interfaces
3.2.11.1 Serial port
Two serial ports, COM 1 and COM 2, are provided for data transmission using the
MEDIBUS.X communication protocol.
3.2.11.2 USB port
After a suitable USB flash drive is connected, the USB port enables, e.g., the
following actions:
– Saving the screen contents as a screenshot.
– Saving and loading device configurations.
– Saving system test results or records as a text file.
Note the additional information on the specification of the USB port (see "Technical
data", page 267).
3.2.11.3 Network port
If an appropriate service contract has been obtained, the Dräger Remote Service
function can be executed.
The device can be connected to the Dräger ServiceConnect Gateway or a
DrägerService computer.
Gas
Central
supply
Gas cylinders
O
2 Yes Permanently mounted Dräger pressure reducer
(option)
or
Third-party manufacturer pressure reducer
Air Yes Permanently mounted Dräger pressure reducer
(option)
or
Third-party manufacturer pressure reducer
N
2O Yes (option)