Operation
54 Instructions for use Babytherm 8004/8010
4 The peripheral temperature is displayed as
soon as the peripheral skin temperature sensor
is attached.
5 The symbol for the peripheral skin temperature
lights up.
If 3 dashes appear on the display, see "System
faults - radiant warmer" on page 92. The measured
value of the peripheral temperature has no effect on
the radiant warmer control. Both skin temperatures
can be displayed when the radiant warmer is
operating in man. mode.
Data output via interface, optional
The core and peripheral temperature can be
displayed in graphic form.
Prerequisites:
– Interface option
– MediCable connecting lead
– Monitor compatible with the MEDIBUS protocol
and complying with the requirements of
EN 60601-1 and EN 60601-1-2.
Following the associated Instructions for Use.
Switching off the radiant warmer
6 Press button.
7 The following message appears on the display:
Radiant heater OFF
Press OK button to confirm
8 Press the OK button.
The radiant warmer will be switched off.
038
7 The following message appears on the display:
Radiant heater turned OFF
6 Press button again = radiant warmer can be
switched on again, see page 47.
To Next Page
General
