To Next PageTo Next PageHow to fix a general error or defect on Dräger X-plore 8000 Respiratory Product?
If you encounter a general error or defect with your Dräger Respiratory Product, re-insert the rechargeable battery in the battery charger. If the error occurs repeatedly, have Dräger Service check the battery charger and rechargeable battery.
Why is the status LED flashing red on my Dräger Medical Equipment?
If the status LED on your Dräger Medical Equipment is flashing red, it indicates a general error or defect. Try re-inserting the rechargeable battery into the battery charger. If the error persists, have Dräger Service check both the battery charger and the rechargeable battery.
What to do if a segment of the battery status indicator is flashing red on my Dräger Medical Equipment?
If a segment of the battery status indicator is flashing red on your Dräger Medical Equipment, it means the remaining battery runtime is low (less than 30 minutes). Recharge the battery as soon as possible or replace it with a fully charged one.
What to do if a segment of the particle filter residual capacity indicator is flashing red on my Dräger Medical Equipment?
If a segment of the particle filter residual capacity indicator is flashing red on your Dräger Medical Equipment, it means that the particle filter residual capacity is low (less than 20%). You should change the particle or combination filter.
What to do if one segment at a time is flashing red on my Dräger Medical Equipment?
If one segment at a time is flashing red on your Dräger Medical Equipment, the general system device must be error checked by Dräger Service.
How to fix a flashing yellow battery status indicator on Dräger Medical Equipment?
If a segment of the battery status indicator is flashing yellow on your Dräger Medical Equipment, it is recommended to recharge the battery soon or replace it with a fully charged battery.
What to do if the flow rate indicator is flashing red on Dräger Medical Equipment?
If a segment of the flow rate indicator is flashing red on your Dräger Medical Equipment, re-check the device function and prepare for use.
What to do if the status LED is flashing red on my Dräger Respiratory Product?
If the status LED on your Dräger Respiratory Product is flashing red, it means you should recharge the battery soon or replace it with a fully charged one.
When to change the particle filter on Dräger X-plore 8000?
If the particle filter residual capacity of your Dräger Respiratory Product is low (less than 20%), you should change the particle or combination filter soon.
What to do if a segment of the particle filter residual capacity indicator is flashing yellow on my Dräger Respiratory Product?
If you see a segment of the particle filter residual capacity indicator flashing yellow on your Dräger Respiratory Product, it means you should change the particle or combination filter soon.
General| Product Type | Powered Air-Purifying Respirator (PAPR) |
|---|---|
| Protection Class | TH3 |
| Charging Time | Approximately 4 hours |
| Air Flow | Minimum 170 l/min |
| Display | LCD with status information |
| Filter Type | Particle filters, gas filters, or combination filters (depending on the application) |
| Alarm | Visual and audible alarms for low battery |
| Approvals | EN 12941 |
| Battery Life | Up to 4-20 hours (depending on battery and operating conditions) |
