Need help?Do you have a question about the Dräger X-plore 8000 Series and is the answer not in the manual?
General| Category | Respiratory Product |
|---|---|
| Battery Type | Lithium-ion |
| Operating Time with Standard Battery | Up to 4 hours |
| Operating Time with Extended Capacity Battery | Up to 8 hours |
| Type | Powered Air-Purifying Respirator (PAPR) |
| Protection Class | TH3 |
| Battery Life | Up to 4 hours (Standard Battery), Up to 8 hours (Extended Capacity Battery) |
| Operating Temperature | -10 °C to +40 °C |
| Ingress Protection | IP65 |
| Approval | EN 12941 |
| Flow Rate | 170 l/min |
| Alarm | Visual, acoustic and vibration |
| IP Protection Class | IP65 |
| Field of Vision | Dependent on headpiece |
| Compatibility | Compatible with various headpieces and filters |
| Certification | EN 12941 |
| Weight (Basic Unit) | Approx. 0.6 kg |
Read and follow all instructions for safe and proper use of product and associated equipment.
Safety guidelines specific to the X-plore 8000 helmet and face shield products.
Explains the symbols and signal words used to indicate potential hazards and precautions.
Provides a general description and list of components for the Dräger X-plore 8000 series facepieces.
Details the functionalities and design of the Dräger X-plore 8000 series facepieces.
Specifies the approved combinations and applications for the Dräger X-plore 8000 facepieces.
Outlines conditions and factors that may impair the protective effect of the facepieces.
Lists the standards and certifications the Dräger X-plore 8000 face shield and helmet meet.
Describes the meaning of symbols and markings found on the product and packaging.
Details necessary conditions, such as contaminant knowledge and oxygen content, before using the product.
Instructions for preparing the facepiece before initial or subsequent use.
Guidelines and warnings for operating the facepiece while in use.
Procedures for cleaning and maintaining the facepiece after use.
Instructions for manually and mechanically cleaning and disinfecting the facepiece.
Procedures for replacing components like foils, shields, frames, padding, sweatbands, and straps.
To Next Page