Dräger X-plore 8000 Cleaning And Maintenance Guide

Dräger X-Plore
®
8000 Cleaning
and Maintenance Guide
Remove and recharge the battery
To remove the battery push down on the blue battery lock tab on the reverse of the unit and fold out. Press the ‘Test’
button to check capacity and replace or recharge as necessary (Fig 2). If charging is required, connect the battery
to the charger unit, connect to a power source and wait until fully charged (Fig 3).
For more information call 01933 672180 email: info@fullsupportgroup.com
www.fullsupportgroup.com
Fig 3. Indication explanation while charging
Fig 2. Battery indicator explanation
Fig 1. Visual inspection
Visually inspect the components
Every time before use, perform a visual inspection of your equipment by checking all parts thoroughly (Fig 1).
Pay particular attention to the lter sealing surface on the fan unit for scratches, damage or contamination.
THE RPE EXPERTS

Dräger X-plore 8000 Specifications

General

Product Type	Powered Air-Purifying Respirator (PAPR)
Protection Class	TH3
Charging Time	Approximately 4 hours
Air Flow	Minimum 170 l/min
Display	LCD with status information
Filter Type	Particle filters, gas filters, or combination filters (depending on the application)
Alarm	Visual and audible alarms for low battery
Approvals	EN 12941
Battery Life	Up to 4-20 hours (depending on battery and operating conditions)