Dräger X-zone 5500 - 11 Configuring the Device

66 Dräger X-zone 5500
Configuring the device
Ending operation
 Switch off the Dräger X-am 5x00 in accordance with the
Instructions for Use.
The visual and the audible alarm will be activated for a
short time before the device switches off.
The X-zone 5500 is in STANDBY mode.
11 Configuring the device
To individually configure a standard-configuration device,
connect the device to a PC.
Communication is carried out with an  USB DIRA III dongle
(order no. 9023820).
The Dräger CC-Vision PC software is used to perform the
configuration.
The following settings can be configured, among others:
 Horn volume
 Wireless function
 Alarm frequencies
 Alarm pattern
 Alarm forwarding
 Life signal (light pattern, horn volume)
 Actions of the switch relay
NOTICE
Observe the documentation and online help of Dräger
CC Vision PC software.
02833112.eps
IR
i
i